If you transport your bike often, you know the routine. Straps over the handlebars. Front suspension compressed. A wheel chock to keep the bike from shifting. It works, but it is not ideal. Over time, this method can stress the suspension, twist the bars slightly, and make loading and unloading more complicated than it needs to be.
This is where Moto Peg Binders from TurnLock change the approach completely. Instead of pulling your bike down from the top, this system locks the bike in from the bottom, right at the footpegs, which is one of the strongest structural points on a bike.
Locking the Bike Where Itโs Strongest
Traditional tie-downs rely on tension from above. The straps compress the forks and hold the bike upright using pressure. With Moto Peg Binders, the holding force comes from the footpegs. A retaining pin slides through the open-style footpeg and connects directly to the binder mounted on your trailer or tray.
No More Crushed Suspension or Twisted Handlebars
When straps pull down from the handlebars, the forks stay under pressure during the entire trip. On rough roads, this constant compression can add wear over time. It can also cause slight movement that may twist the bars out of alignment.
Moto Peg Binders remove this issue completely. The suspension stays in its normal position, and nothing is pulling on the handlebars.
Install and Remove in Seconds
One of the most practical parts of the system is how quickly it works. The TurnLock mechanism uses a push-to-turn action. You position the footpeg, insert the retaining pin, and lock it with a simple twist.
Loading and unloading your bike takes only seconds. There are no straps to tighten, no knots to untangle, and no adjustments to make.
Simple DIY Installation on Your Trailer or Tray
The binders themselves mount to your trailer or ute tray using basic tools. The installation process is designed to be simple and quick. Once fitted, the system is always ready to use. Because it is a fixed mount, you get consistent positioning every time you load your bike.
Designed for Full-Size Dirt Bikes
Moto Peg Binders are made specifically for full-size dirt bikes. For safe use, the bike must have open-style footpegs that can accept the retaining pin. This design ensures a secure mechanical connection rather than relying on strap tension.
TurnLock designs and manufactures this system in Australia with a clear focus on practical use for riders who frequently transport their bikes.
Source: Turnlock
